I need help setting up for ARC2.

[Jerrydpi]

Hi everyone

First time User here, and I need some help setting up my ARC2.


I'm following the Instructions, but I don't understand how to keep the Mic from feedbacking when I pull up the Volume to my normal listening level as instructed in Step 3.

I have adjusted my MIc Input Level to go 1/2 way into the OK area, but as soon as I bring the Volume up I get the feedback.

I'll then lower the Volume just enough to stop the feedback, go to Step 4, but then I get a MultEQ Error that says the measured signal is too low even though output was raised to the maximum available AmpliTube.


What am I doing wrong?

Thanks,
Jerry

[BobF3]

Maybe the gain of the preamp you've connected the mic to is too high

[Meltdowns6]

You need to turn off direct monitoring. The mike isn't supposed to sound through your monitors.

[glass.spur]

Having the same issue and direct monitoring in cubase is certainly off-