How to enable multichannel recording on iRig Stream with iRi

[Lansoir12]

On my Oneplus 7 Pro with Android 10, I am using the iRig record app along with the iRig Stream interface. Although "mono" is turned off on the interface and I can hear a stereo signal when I plug in my headphones, I am unable to select multichannel as it is greyed out. How can I change the channel setting in the iRig record app?

[grahamrodrigue]

On my Oneplus 7 Pro with Android 10, I am using the iRig record app along with the iRig Stream interface. Although "mono" is turned off on the interface and I can hear a stereo signal when I plug in my headphones, I am unable to select multichannel as it is greyed out. How can I change the channel setting in the iRig record app? Doglikesbest

Hello,

To enable multichannel recording on the iRig Stream with the iRig record app on your OnePlus 7 Pro with Android 10, you can try the following steps:

Ensure the MONO - STEREO switch on the iRig Stream interface is set to STEREO.

Launch the iRig recorder app and go to the settings page to select the interface channel.

Insert and remove a headset in the 3.5mm audio port on the phone itself, not the iRig Stream.

This action can sometimes trigger the app to recognize the correct audio input and allow you to select multichannel.

I hope the information may helps you.

[Aimeealey]

It sounds like the iRig Record app may not support multichannel input on Android 10, even if your hardware does. You could try using another recording app like BandLab or Audio Evolution Mobile, which offer more flexible input options. Also, check if the iRig firmware or app has any updates that might unlock multichannel support.