Programing 1 button Amplitube 5 looper with MC8

[rpaulpen]

Hi all,

I'm trying to run the AT5 looper to get record->od->play on one button using Morningstar's MC8. I've seen it down with other controllers but can't seem to figure it out with MC8. Here is a video of what I'm trying to do with a different controller. https://youtu.be/MCfkftTp5xY?si=QL8yd85NaW7Ejp1o&t=942

An help form someone who's had success would be greatly appreciated.

Regards,

RP

[rpaulpen]

So I finally figured this out. When using the MC8 directly connected to Amplitube via AXE I/O, everything works fine. However, when connecting the MC8 power to my Mac to use the Morningstar Editor, it seems to get confused and doesn't send the correct signals.