Hello,
Dear irig developers. Please add the ability to manually adjust the input signal level to the firmware! The device is impossible to use, the guitar input signal level is very low, so it quickly fades (i.e. its sustain is cut off).
It is absolutely impossible to use the device for its intended purpose, the problem is not isolated!
Here is a similar question on Reddit!
https://www.reddit.com/r/GarageBand/comments/18s4urt/irig_hd_x_has_no_ability_to_adjust_input_gain/
P.S.
I will immediately warn you about your possible suggestion to "increase the signal level in the editor" - this does not solve the problem, the signal is "cut off" before it gets to any editor, increasing the volume level in it only increases the volume of the cut signal and does not solve the problem of low gain
