Amp 5

[glass.spur]

As a stand alone I can hear the parallel in my left and right headphone. When I boot up Cubase elements I am unsuccessful in recreating this effect. It seems to be a mono signal and I am unsure how to set this up?

[garfy]

Hi glass.spur

When you instantiate AT5 in Cubase, do you get a choice to open a mono to mono or a mono to stereo version of the plugin?

[glass.spur]

I can do mono in stereo out, don’t know of that’s what you’re referring to

[garfy]

I can do mono in stereo out, don’t know of that’s what you’re referring to

Yep, that's it. That should make the output from AT5 stereo, to include panning of multiple cabs and/or stereo FX. Does it work as you expect ie what you hear in standalone?

[glass.spur]

i have

audio in - mono
config- stereo
audio out- stereo

I don't hear it like the stand alone

[glass.spur]

figured it out- had AmpliTube on mono in instead of stereo in

[glass.spur]

oooppsss, not so fast I hear the changes between single double and triple but no such luck with paralell

[garfy]

What do you mean by parallel? Edit - I'm now guessing you mean the parallel setup at the bottom of the choices. Doh!

Is your input a mono guitar are something like a stereo keyboard?

[glass.spur]

mono guitar-

again I can hear all the changes between one two and three amps in stereo but when parallel goes to mono. Just curious, I am fine with the other settings-

Greg

[garfy]

Gotcha. Sorry Greg, I think I was confused.

The parallel set up is primarily for stereo input, such as a keyboard. If you have it on a mono in/stereo out track, it sends your guitar to both amp/cabs. Check the two amps/cabs are panned L/R in the mixer, but they have almost identical settings so you're probably not 'hearing stereo', just dual mono. Easiest way to tell is by dropping a delay stomp in just before one of the amps and you'll then hear the difference.

If, when you do this, you can still hear the delay only down the middle rather than to one side then there might be something to do with Cubase setup that I don't know about, in which case if no one else chimes in here with advice or a solution the best thing to do is check the FAQs, via https://www.ikmultimedia.com/contact-su ... ck=QUICKSW

If these do not resolve the issue, there is a link to the Technical Support form at the top of the Search FAQs page, for direct help from Official IK Support. They endeavour to reply within 2 working days, but obviously considering the current situation things may take longer than usual.

And, to help others who run into a similar problem, please let us know what you did to resolve the issues, but without directly quoting any correspondence from official support.