Greetings -
I am playing my guitar into a Universal Audio Apollo X - Twin, and into my iMAc / Running Catalina OS. I downloaded Amplitube 4 a couple weeks ago. I've having some success, but am noticing that sometimes I will pull up an Amp - say for example '64 Vibroverb, and literally get no Reverb out of it. Turn up Reverb to 10 and nothing... I've noticed this several times. No matter what I do no reverb, or basically limited response to any changes. Tone is mostly clean, then I'll switch to a saved tone and that one works.
2) Sometimes when I click and open Amplitube I get serious feedback. I close it, open it again and nothing...
Would appreciate your thoughts on this. Obviously it's to diagnose my situation without sitting at my computer, but maybe there is a setting or two I should check out.
Is there a setting checklist document I should reference. I'm using Amplitube as a stand-alone (not through Luna or any other DAW), but the UA Apollo console software does appear to sit in front of Amplitube and controls what's happening.
