Hi there,
i'm using a Behringer FCV100 with Midi through an Ampero Control.
The pedal works but only on 20% of the full pedalrange from Minimum to Maximum (0 to 127)
Calibration in Amplitube doesn't change anything. When i use the pedal in the minimum position the amplitube pedals (wah, volume or something else) use 0%. Only 1cm lifting up the pedal is 100% level. How can i use the whole way of the pedal.
The Pedal ist working fine in any other situation. (using with amp or something else)
Hope you can understand my question an problem.
Thx
Tobi
