AmpliTube does not recognize Focusrite ASIO

[mtherrington]

[Mod Note - moved to appropriate forum]

I am trying to set up AmpliTube with my 2nd gen Scarlett Solo.

I have the Focusrite ASIO drivers installed, v4.65.5. I have AmpliTube v4.10.0 installed.

I have speakers plugged in to the back of the Scarlett, so it is my device for both input and output.

In Amplitube, I get sound if I select 'Windows Audio (Exclusive Mode)' or 'DirectSound,' but there is a lot of latency and it sounds garbled.

If I select ASIO, AmpliTube recognizes 'Focusrite USB ASIO.' However, I do not get an input. The levels do not change - AmpliTube is not hearing anything at all. Nothing changes when I mess with Sample Rate or Buffer Size.

What do I need to adjust in order to use AmpliTube?

[garfy]

Hi mtherrington and welcome to the forums.

The instrument input on the Scarlett Solo is channel 2. In the Audio MIDI setup in AT4 make sure that Channel 2 is selected as the Left Channel.

Hope that helps. Let us know how you get on.

[mtherrington]

Thank you for the response. Yes, I was aware that channel 2 was the instrument input and I had made sure to select it in AmpliTube.

[garfy]

Yes, I was aware that channel 2 was the instrument input and I had made sure to select it in AmpliTube.

Hmm, do you have any other software such as a DAW that you can check that input with, just to rule out a hardware problem?