I uploaded a final batch of tone models for Zentone 7, which is a low power class A tube amp. There are now models for five single ended output tube types; EL84, 6V6, 6L6, EL34 and KT77. For each tube, there are five different types of tones.
1) Clean: Clean preamp configuration, low gain control setting
2) Triode: Clean preamp configuration, high gain control setting, output tube in triode mode
3) Drive: Med gain preamp configuration, high gain control setting
4) Drive2: High gain preamp configuration, low gain control setting, half power setting
5) Lead: High gain preamp configuration, high gain control setting
The Drive2 tones also use a 12AT7 preamp tube which has 60% of the gain found in the normally used 12AX7 tube.
Remember that these tones are amp only and don't include a cab.
One interesting side note. The EL34 and KT77 tubes require heater currents that result in a total current about 10-15% above the maximum 6.3V transformer spec. But since each capture requires that the amp is only powered on for about 5 minutes, it shouldn't cause damage to the amp. So because of this new machine learning tech, I can have amp tones that would not normally be available without resulting in potential long term damage to the amp.
