iLoud MTM Monitors for Dolby Atmos?

Discussion about IK monitors and speakers like iLoud MTM, iLoud Micro Monitor and iLoud

iLoud MTM Monitors for Dolby Atmos?

Postby kofi.bansah@gmail.com » Sun Sep 05, 2021 3:11 pm

Hello guys. I hope you're all keeping safe and staying masked up!.

I have a fairly decent set up but I am thinking of building a new space and make it atmos compatible. Is it possible to use the iLoud MTM Monitors for a Dolby Atmos set up? I'm curious because I have scored online for answers and haven't seen anything of note. If yes, how will one go about calibrating the set up?. What subs can be used efficiently with the MTMs etc... too many questions and zero answers.

Please forgive me if I come off as a noob but I'll be eternally grateful for some constructive contributions and or comments from persons who have attempted or successfully use this monitors in such a manner.

Danke.
kofi.bansah@gmail.com
 
Posts: 1
Joined: Sun Sep 05, 2021 3:07 pm

Re: iLoud MTM Monitors for Dolby Atmos?

Postby mclac53 » Thu Sep 30, 2021 6:27 am

I was wondering the exact same. Obviously. I have a stereo pair of MTM's now. I think any good pair subs should be okay tho. And as far as calibration goes, I figure you would just cal each speaker as you would with a stereo pair (one at a time). Also ik could just make a iLoud sub with cal. Lol. 8" similar design. I'd buy 2
mclac53
 
Posts: 1
Joined: Thu Sep 30, 2021 6:22 am

Re: iLoud MTM Monitors for Dolby Atmos?

Postby thegingerlair » Tue Oct 12, 2021 11:59 pm

Honestly I don't see any reason why you couldn't. Just make sure your room is small enough and run some measurements using the dolby DAART graph. It should give you all the answers you need. You might end up better off getting an ARC license, running that, then recreating the curves with dolbys output software or something similar. I'd suggest a trinnov but those are really expensive for a budget setup. Your main issue is going to be bass management that you will have to tackle using arc software and additional subs.
thegingerlair
 
Posts: 1
Joined: Mon Jan 27, 2020 4:49 am

Re: iLoud MTM Monitors for Dolby Atmos?

Postby Rollo247 » Mon Oct 25, 2021 10:36 pm

Has anyone successfully use these in an Atmos setup? I'm seriously considering it. Could anyone from IK chime in on this?
Rollo247
 
Posts: 1
Joined: Mon Oct 25, 2021 10:34 pm


Return to IK Monitors and Speakers