Blueboard setup issues - buttons light up when pedal is off

[ktaggart@mac.com]

I purchased the iRig Blueboard when I purchased AmpliTube for Mac (macOS 10.12.6, 2017 iMac).

The Blueboard arrived with no instructions whatsoever and just a funny little booklet full of pictograms that are absolutely useless.

So I just fiddled around with it until I finally got the MIDI setting working (it would not allow me to select the Blueboard the first few times I tried it), and the Blueboard app is a fairly non-obvious piece of work.

Anyway, I finally muddled through setting up my pedals via the MIDI panel, but when I selected "Bypass" on all the pedals in order to turn them on/off, the Blueboard toggles the opposite of what I would expect; I have to tap the button off (light out) to activate the pedal (out of bypass). Conversely, to have my four pedals in bypass, all the Blueboard buttons are lit up - and draining the batteries.

What's the secret to getting the Blueboard to act like a normal pedalboard, with the button(s) lit up when the pedal(s) are active and off when in bypass mode?

[pietronet]

Hi,

Same issue here ... Did you find a solution ?

Thank you,

[Peter_IK]

Typically iRig BlueBoard should work as expected with the buttons lit when enabled so if you are not having this experience and other users have not chimed in with suggestions in this forum I suggest seeking official IK support via http://www.ikmultimedia.com/contact-sup ... -hardware/

[darioguziur]

Hi,

It's happening the same thing to me, I have tried all the combinations, but it just won't work the right way, that's really annoying.

[Peter_IK]

Hi,

It's happening the same thing to me, I have tried all the combinations, but it just won't work the right way, that's really annoying.

Hi please open a ticket with IK Support and they will assist you directly at http://www.ikmultimedia.com/contact-support Thanks!

[tizbar050575]

Hi! Excuse for my bad english!:)
I’ve buyed BlueBoard and I had the same problem...but I
Resolve it!
You have to go in Midi (right bottom), select Control Change,
Preset, add and select the pedal you want ti control selecting bypass. The invert min
And max ( min. Must be 100% and max 0%)
It works perfectly!!!!

Tiziano.

[nazleen38]

i solve my problem. Thanks a lot bro

[Peter_IK]

As this thread has been resolved for the user it will be marked as such and locked to keep the forum tidy.

• If you are the original poster and wish to add a comment please ask a Moderator to unlock the thread.
• If you are reading this thread because you are having similar issues or have questions of a related nature, please feel free to start a new topic.